oldskoolstang
01-05-2013, 11:09 PM
Used 342 28 oz sbf rotating assembly. (5.315 rod/3.4 stroke/4.000 bore). RPM 4340 crank, Probe H-beam 5.315 rods, Probe CHP street fighter 4.000 pistons (crap).......I would replace the pistons because one I would not run, but the crank and rods are fine.
Crank is fresh from being checked out and turned .010 on mains and rods. Bill was $150 for the work.....
I do not have rings nor bearings. I do have a new Summit 28 oz balancer that goes with it, but I don't have a flywheel.
If you buy the rotating assembly I will give you a 4.030 stroker clearanced 302 block. It may need to go to .040 to be ran, but I'm not sure.....
Asking: $550 FIRM for it all. I will not take less.
Thanks,
Nathan
912-8 five 6-2601
Crank is fresh from being checked out and turned .010 on mains and rods. Bill was $150 for the work.....
I do not have rings nor bearings. I do have a new Summit 28 oz balancer that goes with it, but I don't have a flywheel.
If you buy the rotating assembly I will give you a 4.030 stroker clearanced 302 block. It may need to go to .040 to be ran, but I'm not sure.....
Asking: $550 FIRM for it all. I will not take less.
Thanks,
Nathan
912-8 five 6-2601