PDA

View Full Version : autometer gauge senders

BigdaddyDupree
10-28-2009, 01:04 PM
i got a full set of autometer gauges from zac and now i need to get some senders for them so i can wire it all up. it is the phantom gauges i have oil pressure, voltmeter, fuel level and water temp. i can do the tach and speedo. im not sure if they are mechanical or electrical zac can chime in with that. what do i need is what im asking? i have never put gauges like these in.
Pesce Nero
10-28-2009, 01:36 PM
I can provide a sender for the volt meter:hysterical:
clubracergt1
10-28-2009, 04:35 PM
www.summitracing.com

www.jegs.com

www.autometer.com

Noticing a trend yet?
WTFWSAT
10-28-2009, 04:39 PM
go to the autometer site figure out what ohms the gauges are the find the correct sending unit.
soccerspike15
10-28-2009, 04:51 PM
go to the autometer site figure out what ohms the gauges are the find the correct sending unit.ditto serial number should tell you how many ohms on the autometer website
Illusions
10-28-2009, 05:26 PM
they won't work with your setup, so sell them to me for oh say $20 :)
LXtasy
10-28-2009, 05:32 PM
I was thinking $25. But hey, I was going to give the benefit of the doubt that they are in EXCELLENT CONDITION
BigdaddyDupree
10-28-2009, 07:35 PM
www.summitracing.com

www.jegs.com

www.autometer.com

Noticing a trend yet?

your a smart ass.
clubracergt1
10-29-2009, 06:19 AM
your a smart ass.

Yes, I am. Thank you very much.