want to borrow bearing heater

[Pesce Nero]

i need to borrow a heater to heat up the bearings to install them in my rear end. The one that you sit the bearings on and turn it on to make it easier to install. anyone got one i can use for a few days?


thanks

[BAD BOB]

? where are you installing them too?

[Pesce Nero]

well this is tyler. i have to put the bearings on the pinion and on the spool in my 9"

[04ctd]

i got a toaster oven i can call a "bearing heater" and rent to you for a profit...

or we can call it a toaster oven, and you can just borrow it for free....

[1998ta__1991rs]

just press them on

[BAD BOB]

just press them on

thats what im sayin. i never done a 9" but i would think they are all the same. Zac got the same style RACE rear end and like the axle bearings you just press them on

[BAD BOB]

.......with a press

[05Saleen]

A little oil and press them on.

[Matts94Z28]

.......with a press

sledge hammer. :poke:

[ElecTech]

You could go buy a hotplate.....

[BigHemi]

I've never heated bearings to install them on a rearend, just press them on. Not sure I've ever heard of a bearing heater...a hot plate, yes, for some small stuff that's hard to press w/o tearing up.

[bwelch]

I've never heated bearings to install them on a rearend, just press them on. Not sure I've ever heard of a bearing heater...a hot plate, yes, for some small stuff that's hard to press w/o tearing up.

They make a cone shaped heater for building rear ends. You can put the bearing and the ring gear on it. I only used one to heat the ring gear up for easy installation. I just press the bearings on.

[BigdaddyDupree]

yup. put the spool in the freezer and the ring gear and bearings on the heater and get it done. its easy

[BAD BOB]

its easy anyways

[toybreaker]

I have a bearing oven. If you still need it PM me and we can work it out.