PDA

View Full Version : Calling out BadBob

silver fox
03-28-2011, 01:01 PM
Calling out BadBob.:joke: To help me. Can you weld cast aluminum? Like on a transmission case.
BAD BOB
03-28-2011, 01:16 PM
im sure just depends on how accessable it is
bwelch
03-28-2011, 02:07 PM
I think he is busy putting a 6.0 and 88mm on the rcf....lol
silver fox
03-28-2011, 04:01 PM
Maybe if I help him install it he will knock some off my bill.LOL. I might try to talk him out of that old motor while I'm there. BadBob I will try to run it by there Fri. Thanks.
ForceFed4g63
03-28-2011, 04:24 PM
Don't mean to hijack the thread but do you have a lift where you are? I need an o2 bung welded on my downpipe and would much rather do it without taking the downpipe off.
bwelch
03-28-2011, 04:38 PM
Bad Bob has a lift. Bob's Masterbend 225 Old Trolley Rd (843) 871-1465
BAD BOB
03-28-2011, 04:41 PM
thanks brian. yes i do have a few lifts and i can weld in a O2 bung as long as i can get to it to drill the hole and weld it up
OUTLAW
03-28-2011, 07:13 PM
silver fox are you ready to BUY this stang ?
silver fox
03-28-2011, 08:09 PM
Outlaw I would love to have it. Haven't worked in a 1 1/2 years. If you would take my 8.60 street car in trade and set me up on a 30 year loan I might be able to get it.:mrgreen: Outlaw don't sell it you will regret it.:bigthumb:
OUTLAW
03-28-2011, 08:38 PM
Outlaw I would love to have it. Haven't worked in a 1 1/2 years. If you would take my 8.60 street car in trade and set me up on a 30 year loan I might be able to get it.:mrgreen: Outlaw don't sell it you will regret it.:bigthumb:

tell pop that the truck is in the paint shop
silver fox
03-28-2011, 09:10 PM
You going to make the old man buy that truck back. That truck and my mustang would be a good race if you would give me the leave.:mrgreen:
OUTLAW
03-28-2011, 09:29 PM
that truck cant get out the 10s
ForceFed4g63
03-28-2011, 10:19 PM
thanks brian. yes i do have a few lifts and i can weld in a O2 bung as long as i can get to it to drill the hole and weld it up

Awesome I'll send you a pm to set up a time when I get the bung in.
BAD BOB
03-28-2011, 10:22 PM
ok i normally have plenty of bungs at the shop if you just want to get it from me
ForceFed4g63
03-28-2011, 10:24 PM
Even better, do you have steel and aluminum? I believe the downpipe is stainless but I haven't been under the car to check yet.
BAD BOB
03-28-2011, 10:42 PM
i believe that mine is stainless. either way if the bung is steel or stainless it can be welded to your stainless down pipe. just as long as it isnt aluminum
ForceFed4g63
03-28-2011, 10:44 PM
Good deal, I'm gonna need a plug as well since I don't have the wideband quite yet, got any of those laying around?