PDA

View Full Version : Need local fabricator/ welder

WWhittle
07-19-2011, 09:35 PM
Just a small, quick job. I need someone to weld some tabs on the front of my pit ride for my pushbar for the hotrod. I'm very picky, so it needs to be someone who can weld very good! If I wanted it to look like shit I would do it myself!! LOL.

Tabs something like these: http://www.summitracing.com/parts/AAF-ALL60002/

Pretty simple- just weld tabs to brush guard on the ATV and that's it. I don't have any tabs, so if you have the tabs or can just make some that's even better.

Need it done ASAP!

Thanks
BAD BOB
07-19-2011, 09:39 PM
when we talking asap? i got a mig and tig at the shop but am out right now but should be back in thurday and friday
WWhittle
07-19-2011, 09:52 PM
when we talking asap? i got a mig and tig at the shop but am out right now but should be back in thurday and friday

Thursday would be great. You have any tabs?
BAD BOB
07-19-2011, 09:55 PM
well if i know what size tube it is welding too on the brush gaurd and what size hole for the bolt/pin then i can make or get some
WWhittle
07-19-2011, 10:03 PM
well if i know what size tube it is welding too on the brush gaurd and what size hole for the bolt/pin then i can make or get some

I know it's a 1/2" diameter pin. I will measure tube for you tomorrow. Thanks!
BAD BOB
07-19-2011, 10:17 PM
just message me tomorrow and if the pin that goes through the tabs goes through hiems on the push bar let me know how far apart that need to be. the best, strongest way would be to weld everything to another half of a piece of tubing then just weld the whole unit to the brush bar and make gussets to make it a little stronger so if it gets any side movement. my cell is 200-3196
slowgreen99
07-19-2011, 10:19 PM
Bbmttmff
slowgreen99
07-19-2011, 10:19 PM
smms#2 in a close second :D
ShawnBoyMoody
07-19-2011, 10:35 PM
:ty:
WWhittle
07-19-2011, 10:48 PM
just message me tomorrow and if the pin that goes through the tabs goes through hiems on the push bar let me know how far apart that need to be. the best, strongest way would be to weld everything to another half of a piece of tubing then just weld the whole unit to the brush bar and make gussets to make it a little stronger so if it gets any side movement. my cell is 200-3196

Sounds good to me. I will message you to tomorrow.
WWhittle
07-21-2011, 06:05 PM
BADBOB hooked me up today! Thank you very much! Excellent job for a good price, can't ask for anything else.
BAD BOB
07-21-2011, 08:48 PM
and thanks for allowing me to help out. Hope it all works out, oh and good luck this weekend give them hell