my car on the dyno...
 

<object width="425" height="344"><param name="movie" value="http://www.youtube.com/v/k8nmCs8DGBE&hl=en&fs=1"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/k8nmCs8DGBE&hl=en&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed></object>

295 awhp, looks like you about tore some shit up!

Was it even tied down? Did not look like it.

yeah two straps tight too.... nothing broke.

haha this is what you were talking about in that text..

first time...


http://i44.photobucket.com/albums/f4...2/IMG_0431.jpg


after that..
http://i44.photobucket.com/albums/f4...2/IMG_0432.jpg

damn, looks like yout guys need to learn how to strap a car down, you should have had at least 4 on the back and 2 on the front

the way we strapped it the second time was enough for a 7 second mustang.

WOW! That's some backyard shit right there...

you are an idiot.

Your father, Seriously though... I would have atleast used the "X" pattern. Where was that at and do you have any video of a full run?

295 ? Two fukkin ninety-five ? You have got to be kidding me...mine makes more than that with a dirty filter and a popped MAF...

And as for the lazy azz tiedown...its your car thatll be launched off that dyno...



:bob

they should have least x'd the back, theres nothing there to keep it from moving side to side

there is video of my full pull, but it was still spinning. i will post it up later. the car obviously made more than 295 dave... :D

So how much did it make ?

Godd good good Paul :bigthumb:... I went friggin ballistic, obviously .... let us know your final numbers and all that ...


:bob

Too bad the camera didn't get the guy standing by the car.

What's wrong with 295 rwhp. Mine only make a little more than that.

not on giggle gas :bigthumb:

i made 314 on motor... hahahahaha

So the car probably make's 480-520hp on both kit's

bwahahahahhahahahahahahahahahah yeah.....................

:mrgreen: Was I too generous?

something like that...


oh and that was on one kit....

So are you "tuned" now?

it's getting there, but for the most part yeah.

Public Service Announcement:

I've recently seen an increase in law enforcement pulling people over with license plates frames. It is actually against the law in SC to have a license plate frame and they are using it as probable cause to make traffic stops.

Check your tag lights too.

Let me clarify that...snake is partially correct in that license plate frames that COVER the month and year of expiration are illegal and thats the probable cause which initiates the traffic stop. License plate covers also fall into this category. And yes, check your plate lights as well as reverse lights...but we all are doing that anyway before we hit the road...right ?



:bob

I got a $232.50 careless opperations ticket for no tag light!

56-3-1240. Display of license plates; missing plate.
ARTICLE 9. LICENSE PLATES AND REGISTRATION CARDS GENERALLY

License plates issued for motor vehicles must be attached to the outside rear of the vehicle, open to view. However, on truck tractors and road tractors the plates must be attached to the outside front of the vehicle provided that single unit commercial motor vehicles with a gross vehicle weight rating in excess of twenty-six thousand pounds may have the license plate on either the outside front or rear of the vehicle. Every license plate, at all times, must be fastened securely in a horizontal and upright position to the vehicle for which it was issued so as to prevent the plate from swinging. The bottom of the plate must be at a height of not less than twelve inches from the ground in a place and position clearly visible as provided in Section 56-5-4530, and it must be maintained free from foreign materials and in a clearly legible condition. No other license plate, lighting equipment, except as permitted in Section 56-5-4530, tag, sign, monogram, tinted cover, or inscription of metal or other material may be displayed above, around, or upon the plate other than that which is authorized and issued by the Department of Motor Vehicles for purpose of validating a plate. It is not unlawful to place a decal on the license plate if it does not obscure any letters or numbers. A motor vehicle owner may attach a trailer hitch to a motor vehicle provided the hitch does not obscure more than two inches of the license plate issued to the motor vehicle. It is unlawful to operate or drive a motor vehicle with the license plate missing and a person who is convicted for violating this section must be punished as provided by Section 56-3-2520.

I got pulled for having a license plate cover earlier this year.

i got pulled for it, i used a dremel and cut out the date area and it has been fine since...

wait!!!!!

seatbelt ticket = $25

no lic plate light = $232???????????

tell me how this makes since??

Better yet, No Motorcycle helmet.......Free

Theres a ticket 4 no helmet, well if your under 21

Thank you snake for posting this up...:bigthumb:


:bob

Quick question....the horizontal mounted thing....Does that apply to bikes? And what about the gangstas with the diagonal plates in the tailgates and stuff?

Just to be clear, I'm not saying LE is going to write a ticket for a license plate frame. It just gives them probable cause to make a traffic stop and start sniffing around for other things.

Especially if you are driving a fast car.

Take it for what it's worth.

yay, so im out of the loop then :cheers

Well I am not a fan of diagonal tags. But it isn't all "gangster" lol.

I had a license plate frame on my red truck. Even had an AFTERMARKET non OEM tag light as well. And tag was on drivers side in the tailgate and I never got pulled over for it.

BUT. I do know that the bottom of your license plate must be a MINIMUM of 12"s above the ground though, as in Goose Creek that is a $220+ ticket right off the bat.