GT500 on the Dyno
 

Got some bad belt slip to fix next week, then going to address the traction issues.

<iframe width="420" height="315" src="http://www.youtube.com/embed/KwRN0gryOZk" frameborder="0" allowfullscreen></iframe>

tell travis he needs to clean the shop

lol. I think he just did.

scary! what numbers did it make? what do you think it will make after fixing the belt slip?

It did mid 6xx hp and low 7xx tq. I cant really guess with the spinning and slipping but would be mid 700's based off the torque numbers that run if the belt had not crapped clear out at 5k rpm.

what have you done to the car?

about the same power my buddy makes with just minor bolt ons, pulley and tune. Them cars are ridiculous.

It's a TVS swap with bolt ons.

How much boost? I think he's at 13psi but I could be totally wrong. He made 640 with air intake mufflers pulley and tune.

I'm somewhere between 20 and 22psi. If he is on the stock SC he should be around 550 but could be over 600 if it's ported.

you are right, i just asked him and he said 540, and blower is untouched. only mods are what was mentioned, it was tuned by amazon...

its his daily so he doesnt race..

.
 

What was causing it to smoke so much?

That was tire smoke on the dyno