Quote:
Originally Posted by SWThomas
I have an LC-1/XD-16 combo and I decided to go ahead and hook-up my 9-Pin Mini-Din Cable so I can datalog A/F though SCT's LiveLink software. I connected the correct wires of the cable to the correct analog wires of the LC-1 in accordance with these instructions...
http://www.innovatemotorsports.com/r...2_tutorial.php |
Dont go by the color pinouts. My cable didnt match up to what they said. I actually had to use a multimeter to determine which color wires go to the 3 pins mentioned.
This is how my ended up being connected rather than what the directions said.
Wire.............................................. ........................LC-1 Harness
Top Right pin........Grey................................... .........Brown
Middle Right pin.....Green..................................... .....Yellow
Bottom Right pin....Brown...................................... ....Ground
Quote:
Originally Posted by SWThomas
I also found a good ground on the chasis and ran all the appropriate ground to that location. I plug the cable into the XCal2 and try to datalog analog 2 and I can't get anything. Right now all I'm trying to do is figure out what my ground-offset is and I can't even get it to log voltage.
|
Refer to above probably your problem.
Quote:
Originally Posted by SWThomas
Also, when I connect to the LC-1 through LM Programmer, I set both the 0 and the 5 volt cells to 2.5v and check the use Air-Fuel box then hit program. I closed it out and then re-open it and the voltages are still set to 2.5 like I commanded but the Lambda box is now checked. I've tried several different times to check the use A/F box and program it and it won't save it that way. Every time I open LM Programmer, it's set itself back to Lambda. Why is it doing this and is there anything else I can check to try and get the my XCal2 to read the analog signal from the LC-1???
|
When I did mine I just hit the "reset to default" button. Try that and see if it works for you
If you need some help and need me to talk you throug it give me a call @ 843 412 4046