Carolina Horsepower - View Single Post - Need to pick everyones brains about the Detroit TT install again.

WTFWSAT · 01-30-2009, 11:30 PM

One thing to check is to make sure your carrier bearings are seated all the way down. If you are using the same shims it Should go right back in but depending on tolerances you have have to slightly adjust. I may get scolded for saying this but you could lightly tap the shim if it doesnt want to go dont force it too far.

I know that mofo is heavy but sliding the whole thing in at once would be best.

just my .02

Chris

01-30-2009, 11:30 PM	#4
WTFWSAT Senior Member Join Date: Nov 2007 Location: Summerville Posts: 861	One thing to check is to make sure your carrier bearings are seated all the way down. If you are using the same shims it Should go right back in but depending on tolerances you have have to slightly adjust. I may get scolded for saying this but you could lightly tap the shim if it doesnt want to go dont force it too far. I know that mofo is heavy but sliding the whole thing in at once would be best. just my .02 Chris __________________ Fastest stock computer 5.0 on the planet! Looking for cheeep msd 6al! PM me! 88 Coupe (turtle) 03 Cobra (tortoise)