Quote:
Originally Posted by Zacharyx
after 2002 all mustang blocks where the same, the earlier romeo and windsor iron blocks needed to be clearanced for the counterweights of a cobra crank, windsor cranks also have an 8 bolt crank on the nodular cranks. Windsor were only used in mustangs from 99-01. there is also a difference in the heads used in the Windsor Plant and Romeo plants, the heads are interchangeable but not the valve covers
when was the hyland book written??
|
The Hyland book was printed 01 Dec, 2007
http://www.amazon.com/Build-Max-Perf...sr=8-1-catcorr
Where did you get info in your post from? Just curious because I want to confirm when Windsor engines were used in Mustangs.
I do have the Cobra crank, heads, chain cover, intake... The block is all that I'm concerned with.
Found some more info..
http://webcache.googleusercontent.co...&ct=clnk&gl=us
Windsor Blocks
1999-’04
The F75E blocks that were used from ’99-’04 were identical to the original F75E castings except that they had an 8.0mm hole for the new knock sensor. The Windsor motor was used in the pickups along with the Mustang and the Expedition in ’99, in the Mustang in ’00, and in the F150 Supercrew, four door pickups from ’01 through ’04.
Seems I can't really get a straight answer from web sources until refrencing the Sean Hyland book. Hyland says that when supply for Mustang engines were low, blocks were sourced from the Windsor plant.
Take a look at this thread,
http://webcache.googleusercontent.co...&ct=clnk&gl=us