SBF 342 rotating assembly

oldskoolstang · 01-05-2013, 10:57 PM

I have a new, never ran 342 Probe 28 oz stroker kit (5.4 rod/3.4 stroke/ 4.000 bore) that i don't see me doing anything with. It has flat top 2 valve relief pistons for in-line heads. I-beam rods, cast crank, forged pistons.

I also have a Comp Mutha Thumper roller cam, Pro Products balancer and a new flywheel (manual) that comes with it.

I do not have rings nor bearings. Motor was assembled in a 4.030 block when I got it and the rings were fucked.....It had cheap ass bearing so i threw them away so I didn't accidentally use them in something.....

I also have a 302 shortblock that I thought about getting checked out and maybe using the block for this build. If you buy the rotating assembly the 302 shortblock comes with it for free.....

Asking: $750 FIRM for everything. I will not take less, don't even ask....

Thanks,
Nathan
912-8 five 6-2601

01-05-2013, 10:57 PM	#1
oldskoolstang Senior Member Join Date: Apr 2012 Location: Guyton, GA Posts: 1,412	SBF 342 rotating assembly I have a new, never ran 342 Probe 28 oz stroker kit (5.4 rod/3.4 stroke/ 4.000 bore) that i don't see me doing anything with. It has flat top 2 valve relief pistons for in-line heads. I-beam rods, cast crank, forged pistons. I also have a Comp Mutha Thumper roller cam, Pro Products balancer and a new flywheel (manual) that comes with it. I do not have rings nor bearings. Motor was assembled in a 4.030 block when I got it and the rings were fucked.....It had cheap ass bearing so i threw them away so I didn't accidentally use them in something..... I also have a 302 shortblock that I thought about getting checked out and maybe using the block for this build. If you buy the rotating assembly the 302 shortblock comes with it for free..... Asking: $750 FIRM for everything. I will not take less, don't even ask.... Thanks, Nathan 912-8 five 6-2601 __________________ Working on junk....