Need local fabricator/ welder

BAD BOB · 07-19-2011, 10:17 PM

just message me tomorrow and if the pin that goes through the tabs goes through hiems on the push bar let me know how far apart that need to be. the best, strongest way would be to weld everything to another half of a piece of tubing then just weld the whole unit to the brush bar and make gussets to make it a little stronger so if it gets any side movement. my cell is 200-3196

07-19-2011, 10:17 PM	#6
BAD BOB Senior Member Join Date: Mar 2008 Location: SUMMERVILLE Posts: 3,681	just message me tomorrow and if the pin that goes through the tabs goes through hiems on the push bar let me know how far apart that need to be. the best, strongest way would be to weld everything to another half of a piece of tubing then just weld the whole unit to the brush bar and make gussets to make it a little stronger so if it gets any side movement. my cell is 200-3196 __________________ IM BAD BOB

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode