|
11-17-2011, 11:02 PM
|
#1 |
|
Senior Member
Join Date: Jan 2010
Location: Charleston
Posts: 904
|
Intercooler piping.
So my FMIC piping is kind of a hack job on the drivers side and keeps trying to come apart under full boost. Any recommendations on someone who can fab up a one piece (preferably) blower to intercooler setup around here?
__________________
Never argue with an idiot. They will drag you down to their level then beat you with experience. The reason I swear so much is because, fuck you. |
|
|
|
11-17-2011, 11:14 PM
|
#2 |
|
Senior Member
Join Date: Jun 2008
Location: Goose Creek
Posts: 763
|
__________________
 
|
|
|
|
|
11-17-2011, 11:23 PM
|
#3 |
|
Senior Member
Join Date: Jan 2010
Location: Charleston
Posts: 904
|
Was looking into doing similar (I have a bit of piping from an old build) but no access to a welder. Also after buying the pipes, cutter, and another set of vise grips I would more then likely have spent about as much as just paying someone else to do it.
Also, would like to have it done soon as possible so don't want to wait for stuff to be shipped.
__________________
Never argue with an idiot. They will drag you down to their level then beat you with experience. The reason I swear so much is because, fuck you. |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
