transbrake and 2 step wiring

Chillerman · 03-20-2010, 08:41 PM

After reviewing your synergy wiring diagram, the two-step wants to see the ground input just like you show it in diagram number 1 in your first post. Wire it just the way you showed it in that picture and it should work just fine. Just make sure you use a momentary switch as well for the transbrake relay. If this gets too confusing, then get a double pole double throw relay that has isolated contacts and use one momentary to drive the relay, then the relay will drive both the brake and the two-step. If this still blows your mind, then pm me your cell number and I can call you sometime tomorrow afternoon.

03-20-2010, 08:41 PM	#15
Chillerman Senior Member Join Date: Nov 2007 Location: Goose Creek Posts: 1,232	After reviewing your synergy wiring diagram, the two-step wants to see the ground input just like you show it in diagram number 1 in your first post. Wire it just the way you showed it in that picture and it should work just fine. Just make sure you use a momentary switch as well for the transbrake relay. If this gets too confusing, then get a double pole double throw relay that has isolated contacts and use one momentary to drive the relay, then the relay will drive both the brake and the two-step. If this still blows your mind, then pm me your cell number and I can call you sometime tomorrow afternoon. __________________ 88 Mustang LX mild 302, no laughing gas, and the rest is secret. Best 1/8th 7.843 @ 87.98, best 1/4 12.427 @ 111.20, best 60 1.601 89 Mustang LX wheels up @ Pinks All Out

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode