Fox UCA mount problems. Need help.

[Bradleyrj]

Ok. So the tard who had the car before me fubar'd the rear UCA Mounts on the body. They removed and replaced the mounts with what is pictured below. The "Mounts" are bolted to the car with 4 bolts. There is a metal plate inside the car "under the back seat" that sandwiches the factory floor pan and is bolted down using the 4 bolts via the mount underneath the car. (Make sense??)

What I DONT like about this setup is the fact that the UCA isnt completely supported. There is only one "side" of the arm supported. IMO NOT Kosher at all. So Looking for some knowledge.. how would you fix this?

Weld it all up and add a plate so both sides of the arm are supported? (Ghetto but cost efficient and effective) Scratch it completely and install a Wild Rides S-Box (Effective but not cost efficient) or....

Here are some pics of what I'm working with. You can see that the arm geometry between the UCA and Mount is not correct? Is the Arm wrong? Or is the Mount incorrect?


Drivers Side:



Passenger side:



Example of incorrect geometry: This is the passenger side mount.


Never mind the ghetto blue and rigged up exhaust hanger. That's coming off.

Just need some input on what you would do to fix this.