Garage cleaning: Mostly Fox Mustang and 302 based parts

[oldskoolstang]

I'm located 5 miles from exit 109 off I-95 in Georgia. 20 minutes from Savannah, Ga.

I need to clean up the garage and come up with enough money to finish a motor for my Fox. I've pretty much bottom dollar priced everything, but feel free to make me an offer on anything.....

- Explorer GT40 upper and lower intake. Also have stock 65mm throttle body with sensors and elbow. $100

- Loaded front 98 Mustang GT 5 lug spindles (calipers, rotors, pads, hoses all included) $125

- stock explorer 5.0/302 roller shortblock, ~200k miles, $200

- all accessory brackets, pulleys, coil packs, ignition, Mass air, ECM (computer) and engine harness for a 302 in a 96 Explorer. $100

- Rebuildable 4r70w transmission from 96/97 Mountaineer. No converter. $75

- C&L 73 Mass Air Flow meter with 19 lb sample tube and stock electronics. Fits 89-93 Mustangs. $75 obo

- Summit 75 MM Bullet Mass Air Flow Meter. Part number 29051B-C. Calibrated for 24lb injectors. $150 obo SOLD

- Vortech FMU, I don't know what disc is in it. It came with a Supercharger kit I had and I've never used it. $25

- Paxton adjustable fuel pressure regulator for 86-93 Mustang. Mounts on factory rails. It has provision for a gauge, but I don't have the gauge. $50

- Stock 94/95 Mustang fuel rails. SOLD

- Mustang 351W swap shorty headers for Fox. I do not know the brand, but look like they've never been used. 1 5/8 primaries. $75 obo SOLD

- Mustang 351W swap oil pan. It's just a stock one from a E250 van. It comes with the pick-up tube and pan rails. $25

- .030 stock 302 roller block. Probably needs to go to .040 to be ran. Free if you come get it.

- .030 TRW Forged pistons for Trick Flow TW heads (canted valve reliefs only) on stock 5.090 Ford rods with ARP bolts (Makes 306 motor). $150 obo

- COMP Cams Thumpr Retrofit Hydraulic Roller Camshaft 289/302/351W Ford. Part number 35-600-8. 0.531 int./0.515 exh. Duration at 050, 227 int./241 exh. $175 obo

- Summit billet distributor for 86-93 Fox Mustang with TFI module. New MSD cap. $75

Nathan,
912-856-2601
oldskoolstang@yahoo.com

[oldskoolstang]

I will make a package deal on some of this stuff....

[slow94]

possibly interested in gt-40 upper and lower. Need to see if it will fit on my 95 f150 (302) without much modification.

[oldskoolstang]

possibly interested in gt-40 upper and lower. Need to see if it will fit on my 95 f150 (302) without much modification.

$100 and you can have it. I know the throttle body is completely different and I'm pretty sure there are some sensor differences.....I can't remember what all else.

[oldskoolstang]

Here's a link to some info:
http://www.ford-trucks.com/forums/836194-gt40-or-explorer-intake-swap.html

[slow94]

It is a decent deal. Just not sure if it is worth the swap yet. From what I have read so far, it is said that there isn't much gain to be had at all especially with the stock e7 heads. I guess the truck intake is actually pretty good.