All my LS stuff for sale

[oldskoolstang]

To those that do not know, I am located in Guyton, GA less than 10 minutes from exit 109 off I-95 (1st GA exit when coming from S.C.)


I bought a good running old school 350 to swap into my FJ40 Landcruiser and need to sell the LS stuff I've acquired to afford the trans adapter.....

What I've got and prices:
- 5.3 iron block bored to 5.7 (99.0 mm/3.898), block has no bolts; but comes with front and rear covers and knock sensor/valley pan cover. $220
- 13 stock LS1 pistons and rods (still have rings on them) $75
- good stock 5.3 crankshaft $80
- stock 241 heads with stock rockers and pushrods $125
- stock 5.7 Camaro valve covers $35
- stock 5.3 truck valve covers $25
- LS1 Camaro alternator bracket SOLD
- LS1 Camaro p/s bracket SOLD
- Pro Products LS1 Camaro dampner SOLD
- stock 6.0 oil pan with pick-up and windage tray $50
- stock 5.3 intake with throttlebody/injectors/rails $50
- good coil packs from truck $80
- oil dipstick from 5.3 truck motor $10

Buy it all for $500 and I will include every little piece of LS stuff I've got laying around.......

Nathan
912-856-2601
oldskoolstang@yahoo.com

[oldskoolstang]

Weiand intake sold

[AverageJoe]

Originally Posted by oldskoolstang

Also have an ugly lack/white Weiand LS1 intake that I bought from Colin back when I planned on putting an LS into a Mustang....

$200 FIRM (that's what I bought it for)

Zac needs this

[BAD BOB]

Originally Posted by AverageJoe

Zac needs this

I think it's been around

[oldskoolstang]

Originally Posted by BAD BOB

I think it's been around

Yeah, it has.....I meant to sandblast it at my last job, but forgot to and the blast cabinet just took a shit for an unknown reason.....It's a decent intake and much better than a stock ls1 intake....pretty much equivalent to an ls6, just 13 lbs heavier....it weighs 22 lbs.

[GreebeanZ28]

You think this stuff will fit in the back if a vette?

[oldskoolstang]

Originally Posted by GreebeanZ28

You think this stuff will fit in the back if a vette?

I'd bet money it would, lol.....

[Matts94Z28]

Originally Posted by GreebeanZ28

You think this stuff will fit in the back if a vette?

useless

[Illusions]

coil packs the round style with the heat sinks on them?

Any wiring harness for the engine? truck or fbody

[oldskoolstang]

I do have a wiring harness and computer that I also got from Colin. I believe he said it came from a 2000-2002 Camaro. Don't remember if it was an auto or 6 speed, I didn't care as I was going to run a th350 or glide....

on the harness there is a part that goes thru the firewall for the obd2 port that is cut.

I'll take a loss on it and you can have it for $250 if you want....

I will take a picture of the coil packs for you later today.

[oldskoolstang]

Alt bracket, p/s bracket, dampner, and Weiand intake all sold today......Still have everything else..