Aluminum block ls1 motor with spun bearing and more ls parts....
 

I have a 2002 ws6 90k mile (supposedly on all that, I can't verify) aluminum block LS1 with one spun rod bearing. It didn't damage the crank and I have a replacement piston and rod for it.

Asking: $400 obo for it

I also have a 5.3 truck intake with rails/injectors/t.b., a truck oil pan, timing cover, rear cover, camshaft, oil pump, valve covers and dipstick $50 for all

I have a set of untouched 241 casting complete heads with valve covers, stock rockers and rocker trays, and stock pushrods $150 obo

Thanks,
Nathan
912-8 five 6-2601

$500 for it all if you come get it.

Pm'd

Hoe snap!

I still have it and need it gone soon. I'm moving in a month and need to get rid of as much junk as possible....

$450 for it all...

Were you planning on putting all this together for a complete motor?

Yep, I was planning on throwing it together for my fj40 Landcruiser project. I have since gotten a good low mile 350 for cheap and decided to make it simple an use the 350.....

It's still for sale. $400 firm for it all.

$300 for shortblock. Will need new rod bolts since I removed all the rods to check them out. Crank checked out good, I installed a good piston/rod in place of the spun one. So shortblock is complete, but I would replace all bearings ( none were bad), and the rod bolts.

$100 for 241 casting heads/rocker/pushrods/truck pan/truck intake/etc

SOLD!