Just planning ahead

Richard Head · 09-11-2007, 06:03 PM

Chris,
I have the Innovate LC-1 with the X-16 gauge that came with the truck when I bought it. It is a very nice set up that has the ability to perform a wide range of functions if you are technically savvy. I am not, and have been working with/ on it for weeks. I think I have it working and have done some data logging but to put the a/f and corresponding rpm together I have to purchase another $250 add on to get it to do this. From looking at MikeÔÇÖs and using the Dynojet soft ware and helping to install another it appears the other than a cable or two it is a more complete system right out of the box. I am not sure about the cost of each, and remember the fact that when it comes to computers I and functionally illiterate.

09-11-2007, 06:03 PM	#5
Richard Head Supporting Member Join Date: Mar 2007 Posts: 788	Chris, I have the Innovate LC-1 with the X-16 gauge that came with the truck when I bought it. It is a very nice set up that has the ability to perform a wide range of functions if you are technically savvy. I am not, and have been working with/ on it for weeks. I think I have it working and have done some data logging but to put the a/f and corresponding rpm together I have to purchase another $250 add on to get it to do this. From looking at MikeÔÇÖs and using the Dynojet soft ware and helping to install another it appears the other than a cable or two it is a more complete system right out of the box. I am not sure about the cost of each, and remember the fact that when it comes to computers I and functionally illiterate.